Table of Contents
Advertisement
5.5.1
Auto exit config mode
The controller automatically exits the configuration menu when there is no user interaction after an adjustable time. Go to
Timers > General > Auto Exit Config Mode to configure the timer.
The controller saves all the configuration parameter changes before leaving the menu.
5.6
Parameter list
You need to go to the configuration menu to configure the parameters in the parameter list. A password is needed to enter
the menu, and the default is 0123.
More information
See Configuration menu for how to enter the menu and configure the parameters.
5.6.1
Module
General
Parameter
Profile name
Power On mode
Power On lamp test
Deep Sleep Mode
Load Histogram
Auto-Clear Warning
Alarm
Display
Parameter
Contrast
Power Save Mode
User manual 4189341360A EN
Range
-
Manual
AUTO
Enable
Not enabled
Enable
Disable
Enable
Disable
Enable
Disable
Range
0 to 100 %
Enable
Disable
Default
Profile 1
-
Not enabled
Not enabled
Not enabled
Not enabled
Default
80 %
Not enabled
Description
You can change the name of the profile.
The controller operates in this running mode
when you power on the controller.
If this parameter is enabled, the LEDs glow red
for 2 seconds after a power reset.
If this parameter is enabled, the controller goes
into deep sleep mode when the controller is not
in use for an adjustable time.
The load histogram shows the engine running
hours. The running hours are put into load
groups.
If this parameter is enabled, the controller
automatically clears an active alarm, when you
have resolved the condition that activated the
alarm.
Description
Configure the display contrast with this
parameter.
If this parameter is enabled, the controller turns
off the LCD backlight after an adjustable time.
This is only when the engine is not operating.
You can configure the adjustable timer on the
controller or with the smart connect software
here: Timers > General > Power Save
Mode Delay.
Page 32 of 99
Advertisement
Table of Contents
