Deif SGC 420 User Manual page 86

No. Output source
67 Fail to close generator
68 Fail to close mains
69 Loading volt not reached
70 Loading freq not reached
71 MPU loss
72 BTBS Battery hybrid mode
73 Automatic fuel transfer
74 ISV pull signal
75 ISV hold signal
76 Low idle mode
77 Coolant control output
78 Keyswitch
79 Open Gen Breaker Pulse
80 Close Gen Breaker Pulse
81 Open Mains Breaker Pulse
82 Close Mains Breaker Pulse
83 Idle Mode On Pulse
84 Idle Mode Off Pulse
User manual 4189341341B EN
Description
This output is activated when there is a genset breaker failure.
This output is activated when there is a mains breaker failure.
This output is activated when the loading voltage has not reached the
minimum set point during the start sequence.
This output is activated when the loading frequency has not reached the
minimum set point during the start sequence.
This output is activated when there is an MPU failure.
The output is activated when the load is on the site battery and the engine
has stopped (no failure).
Automatic fuel transfer is activated when you activate this output.
This output is activated when a start command is given.
This output is activated when start command is given. The output is active
until the engine has stopped.
This output is activated when the genset is operating at low idle speed.
This output is activated when the coolant temperature is outside the set
points configured for the temperature.
If this output is activated, a pulse is generated to open the genset breaker.
If this output is activated, a pulse is generated to close the genset breaker
If this output is activated, a pulse is generated to open the mains breaker
If this output is activated, a pulse is generated to close the mains breaker
If this output is activated, a pulse is generated to activate idle mode.
If this output is activated, a pulse is generated to deactivate idle mode.
Page 86 of 89