Generic J1939 - Deif SGC 420 User Manual

No. Function
1 Select the engine type from the drop-down list.
2 Select types of measurements from the engine/ECU.
3 Configure the settings for the ECU communication failure alarm.
Configure the settings for the diagnostic lamps on the ECU
• Amber lamp
• Red lamp
4
• Malfunction lamp
• Protect lamp
See the specific documentation for the engine/ECU for more information.
Select the actions that SGC controls for the engine/ECU
• Engine speed
5
• Engine start/stop
• Engine preheat
Configure source addresses for the SGC controller and the engine/ECU.
6
See the specific documentation for the engine/ECU for information about the source address.
8.3

Generic J1939

Basic information
• Engine controller/type: A controller that uses generic J1939.
• DEIF smart connect: Select Generic J1939.
• Complies with the J1939 standard.
• Baud rate: 250 kb/s
Warnings and shutdowns
These standard warnings and shutdowns are supported:
• EIC yellow lamp
• EIC red lamp
• EIC malfunction
• EIC protection
Alarms on the display
The display can show J1939 diagnostic messages DM1 (active alarms) and DM2 (historic alarm log list). You can
acknowledge these alarms from the display. For some engines, the display has a special alarm display (see the specific
engine type).
Push the Down button for 4 seconds to see the alarm log. By default, the alarm log shows the DM1 (active alarms). To
see the historical alarm list, use Down
xxxxxxxxxxxxxxxxxx
xxxxx
xxxx
xxx
Alarm log DM1 shows active alarms
User manual 4189341341B EN
button to select DM2.
DM1
xx
xx
xx
DM2
No historic log
Alarm log DM2 shows historic alarms
Page 80 of 89