Section 12 - Electrical Components; Starter And Starter Solenoid; Neutral Switch; Neutral Switch Removal - Club Car XRT 950 2009 Maintenance And Service Manual

SECTION 12 – ELECTRICAL COMPONENTS
DANGER
• See General Warning on page 1-2.
WARNING
• See General Warning on page 1-2.

STARTER AND STARTER SOLENOID

See General Warning on page 1-2.
Refer to the engine manual for testing, removal, disassembly, and installation procedures. See the Briggs &
Stratton Vanguard engine manual (CC P/N 103568101).

NEUTRAL SWITCH

See General Warning on page 1-2.
The neutral switch (1) is located on top of the transaxle housing (Figure 12-1, Page 12-2).
TESTING THE NEUTRAL SWITCH
See Test Procedure 8 – Neutral Switch (Transaxle) on page 11-26.

NEUTRAL SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Disconnect the two-pin connector between the neutral switch and the wire harness (Figure 12-1, Page 12-2).
3. Use a wrench to loosen and remove the neutral switch from the transmission housing.
2009-2012 XRT 950 Maintenance and Service Manual
12
Page 12-1