Fuel Gauge; Fuel Gauge Removal; Fuel Gauge Installation - Club Car Precedent 2016 Maintenance And Service Manual

ELECTRICAL COMPONENTS – SUBARU EX40

FUEL GAUGE

See General Warnings on page 1-2.
With the key switch in the OFF position, the fuel gauge reads empty. When the key switch is turned to ON, the fuel
gauge becomes active.
TESTING THE FUEL GAUGE
See Test Procedure 22 – Fuel Gauge on page 18-39.

FUEL GAUGE REMOVAL

1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
2. Remove the instrument panel. See Key Switch Removal on page 19-20.
3. Disconnect the three wires from the fuel gauge (Figure 19-25, Page 19-29).
4. Remove the two hex nuts (3) and lock washers (4) from the threaded studs on the back of the gauge (2). Remove
the mounting bracket (5) from the back side of the fuel gauge and remove the gauge from the instrument panel.
BLACK
ORANGE
BLUE
Bracket (5) may vary in appearance.
2437
Figure 19-25 Fuel Gauge Installation

FUEL GAUGE INSTALLATION

1. Install a new fuel gauge into hole in instrument panel until flange seats against panel (Figure 19-25, Page 19-29).
2. Slide the mounting bracket (5) onto the two threaded studs on the fuel gauge and secure with two lock washers
(4) and two hex nuts (3). Tighten to 2.5 in·lb (0.28 N·m). Place one drop of Loctite
Loctite ® to come into contact with the fuel gauge casing.
3. Connect the blue wire from the wire harness to the (I) terminal, the orange wire from the wire harness to the (S)
terminal, and the black wire from the wire harness to the (G) terminal. See Wiring Diagrams on page 18-8.
4. Install the instrument panel.
4.1. Connect the electrical connector (3) (Figure 19-21, Page 19-20).
2
2016 Precedent Golf Car Maintenance and Service Manual
Fuel Gauge
® on each hex nut. Do not allow
Page 19-29
19