Fuel Filter; General Information; Fuel Filter Removal; Fuel Filter Installation - Club Car Precedent Villager 2 Maintenance And Service Manual

21

Fuel Filter

FUEL FILTER
See General Warnings on page 1-2.

GENERAL INFORMATION

The fuel filter is located in the fuel tank. It is part of the fuel pump module assembly and should last the life of the
vehicle; however, it is replaceable if the need should arise. In addition, the module assembly features a fuel pickup
screen to catch larger particles before entering the fuel filter.

FUEL FILTER REMOVAL

1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery.
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. Remove fuel pump module (1). See Fuel Pump Module Removal on page 21-20.
4. Disconnect flex hoses (12 and 13) from filter (14) (Figure 21-15, Page 21-22).
4.1. Pull hose retainer clip straight up and out of filter (14). Do not discard clip.
4.2. Pull flex hoses (12 and 13) straight out of filter inlet and outlet.
5. Remove filter (14) from module (1) and dispose of properly.

FUEL FILTER INSTALLATION

CAUTION
• Fuel filter flex hoses are keyed to aid proper installation into fuel pump module.
NOTE: The fuel filter is keyed to the fuel pump module to prevent incorrect assembly.
The inlet and outlet flex hoses are keyed to the fuel filter ports to prevent incorrect assembly.
1. Orient fuel filter (14) and insert into fuel pump module (1) until fully seated (Figure 21-15, Page 21-22).
2. Connect flex hoses (12 and 13) to the fuel filter (14).
2.1. Orient flex hoses (12 and 13) with matching port in filter (14) and push each hose end straight into filter
until fully seated.
2.2. Push hose retainer clip straight into filter (14) until fully seated.
3. Install fuel pump module (1). See Fuel Pump Module Installation on page 21-20.
4. Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
5. Place the Forward/Reverse handle in the NEUTRAL position, chock the wheels, and the neutral lockout switch in
the MAINTENANCE position (Figure 24-1, Page 24-1).
6. Start the engine and check for fuel leaks. See following DANGER.
DANGER
• Repair all fuel leaks before operating the vehicle.
7. If no leaks are found, place the neutral lockout switch in the OPERATE position (Figure 24-1, Page 24-1).
Page 21-26 2019 Precedent Villager 2 Maintenance and Service Manual
GASOLINE VEHICLE - FUEL SYSTEM