Accelerator Pedal Installation - Gasoline Vehicles - Club Car Carryall 500 2016 Maintenance And Service Manual

5
Accelerator Pedal – Gasoline Vehicles
12. Inspect the accelerator pivot rod supports (21) for wear and damage and replace if necessary. If the pivot
rod supports do not require replacement, loosen, but do not remove, the four bolts (22) and lock nuts (18) to
make installation of the pivot rod easier.
13. Remove the accelerator pedal (1) from the vehicle.
14. Inspect all parts for wear and damage. Replace as necessary.
1
22
26
3000
ACCELERATOR PEDAL INSTALLATION – GASOLINE VEHICLES
1. If the accelerator pivot rod supports were replaced, position the supports (21) on the vehicle frame and install the
four bolts (22), flat washers (19), and lock nuts (18). Finger-tighten nuts at this time (Figure 5-6, Page 5-6).
Page 5-6 2016 Carryall 500 and 700 Maintenance and Service Manual
7
5
6
9
8
25
17
18
19
21
21
Figure 5-6 Accelerator Pedal – Gasoline Vehicles
ACCELERATOR AND BRAKE PEDAL GROUP
10
11
12
17
20
13
14
15
16
25
24