ELECTRICAL SYSTEM TROUBLESHOOTING: IQ
PLUS ELECTRIC VEHICLES
TEST PROCEDURE 2 – 48-Volt Battery Pack Voltage Under Load
See General Warnings on page 1-1.
NOTE: This is a voltage test.
1.
If necessary, see Testing Basics on page 12-14.
2.
Be sure the batteries are fully charged and that the electrolyte level is correct in all cells.
3.
Connect the tester leads to the positive (+) post of battery no.1 and negative (–) post of battery no. 8 (Figure
12-6, Page 12-17).
(–)
(Viewed from driver side of vehicle)
1. RED probe to battery no. 1 (+).
2. BLACK probe to battery no. 8 (-).
2780a
Figure 12-6 Battery Discharge Test
(–)
(Viewed from driver side of vehicle)
1. RED probe to battery no. 1 (+).
2. BLACK probe to battery no. 8 (-).
2781a
Figure 12-7 Battery Discharge Test
4.
Turn the discharge machine on and record the voltage reading of battery pack while under load.
(+)
2016 Carryall 500 and 700 Maintenance and Service Manual
12
Test Procedures
Page 12-17