Instrument Panel Removal; Instrument Panel Installation - Club Car Carryall 500 2016 Maintenance And Service Manual

Gasoline vehicle with subaru ex40 engine electric vehicle with quiq charger
Table of Contents

Advertisement

4
Front Body

INSTRUMENT PANEL REMOVAL

1.
Disconnect the batteries. See Disconnecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
See Side-Post Battery: Disconnecting the Battery-Gasoline Vehicles on page 1-5.
See Top-Post Battery: Disconnecting the Battery-Gasoline Vehicles on page 1-5.
2.
Remove front cowl. See Cowl Removal, Section 4, Page 4-5.
3.
From the inside of the dash, press upper snap tabs (1) of the instrument panel inward to release from dash.
4.
Then push the instrument panel near the bottom (2) to pop out the lower body clips (be careful not to pry the
lower clips off).
5.
Pull instrument panel out from the dash panel (2).

INSTRUMENT PANEL INSTALLATION

1.
Place upper tab of instrument panel into slot (1).
2.
Snap panel into dash while pushing in on the driver and passenger side tabs and sliding the top portion of the
panel into place.
3.
Snap lower body clips in at each lower corner.
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4. See Side-Post
Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
See Top-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
2946
Page 4-10
2016 Carryall 500 and 700 Maintenance and Service Manual
1
Figure 4-4 Instrument Panel
BODY AND TRIM
1
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Carryall 700 2016

Table of Contents