Club Car Carryall 500 2016 Maintenance And Service Manual page 350

20
Voltage Regulator
1
9
1. Red wire to solenoid. 2. To kill limit switch. 3. To frame
ground. 4. To bullet connector.
2973
Figure 20-20 Voltage Regulator
VOLTAGE REGULATOR INSTALLATION
1. Position the voltage regulator (9) in the electrical component box and install the mounting screw (8) (Figure
20-20, Page 20-18). Tighten screw to 23 in·lb (2.6 N·m).
2. Connect the voltage regulator red wire (1) at the large post on the solenoid, the yellow wire (4) at the bullet
connector, and the black wire (7) at the battery frame ground (Figure 20-20, Page 20-18).
3. Install snap-on electrical component box cover. Be sure to firmly press down all corners. Install screw and
tighten to 18 in·lb (2 N·m).
4. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery-Gasoline Vehicles
on page 1-5.
See Top-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
5. Place Forward/Reverse handle in NEUTRAL and place the neutral lockout switch in the MAINTENANCE position.
Start the engine and check regulator for proper functioning as described in the voltage regulator test procedure.
See Voltage Regulator on page 18-36.
Page 20-18 2016 Carryall 500 and 700 Maintenance and Service Manual
2
3
ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE