Club Car Carryall 500 2016 Maintenance And Service Manual page 266

17
Transaxle
2629
Figure 17-8 Disconnect Shocks
6. Disconnect the shock absorbers from their lower mounts (Figure 17-8, Page 17-6).
7. Disconnect the four motor wires. Use two wrenches to prevent the post from turning.
8. With a floor jack supporting the transaxle, remove lower spring shackle nuts and bolts. Rotate shackles up
and away from springs (Figure 17-9, Page 17-6).
9. If a chain hoist was used to raise the vehicle, lift the vehicle high enough to permit easy access and clearance
for removal of the motor. If a floor jack was used to raise the vehicle, lower the transaxle enough to permit
easy access and clearance for removal of the motor.
10. Remove the three motor mounting bolts (Figure 17-11, Page 17-7) and the motor positioning bolt (Figure 17-12,
Page 17-7) mounting the motor to the transaxle. See following CAUTION.
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
CAUTION CONTINUED ON NEXT PAGE
Page 17-6 2016 Carryall 500 and 700 Maintenance and Service Manual
TRANSAXLE: ELECTRIC VEHICLES
2631
Figure 17-9 Detach Spring From Shackles