Grille Installation - Club Car Carryall 500 2016 Maintenance And Service Manual

BODY AND TRIM
7. Remove charger receptacle (if equipped) by removing the three screws that attach the receptacle or disconnect
connector (quick connect).

GRILLE INSTALLATION

1. Connect the charger receptacle or connector (quick connect).
2. Install, but do not tighten upper M6 screws. (Do not tighten screws until plastic bumper is installed).
3. Lower grille holes are shared with the front bumper, ensure lower bumper screws are attached first then install
grille.
4. Line up upper and lower bolt holes.
5. Install and tighten upper bolts, then lower right and left side bolts. Tighten to 44 in·lb (5 N·m).
6. Connect the batteries.See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
See Side-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
See Top-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
2016 Carryall 500 and 700 Maintenance and Service Manual
4
Front Body
Page 4-7