Accelerator Pedal Installation - Club Car Carryall 295 2013 Maintenance And Service Manual

5
Accelerator Pedal
4. Remove the pedal assembly from the return spring pullrod (3). Loosen spring retaining nut if necessary.
5. AWD only: Remove hardware (4) securing the front differential limit switch (5) to the pedal.
6. Inspect the pedal bushings (6) for wear and replace if worn.

ACCELERATOR PEDAL INSTALLATION

1. Installation is reverse of removal procedure.
2. Check return spring length and adjust if necessary (Figure 5-3, Page 5-2).
3. Tighten pedal pivot bolt (1) and locknut (2) to 30 ft-lb (68 N·m).
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
2361
Figure 5-3 Accelerator Pedal Return Spring Length (To
Face Of Nut As Shown)
Page 5-2 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
All manuals and user guides at all-guides.com
2- 7/16 in. (± 1/8)
61 mm ( + 3)
ACCELERATOR AND BRAKE PEDAL ASSEMBLIES