Disabling The Vehicle; Disconnecting The Batteries - Electric Vehicles; Connecting The Batteries - Electric Vehicles - Club Car Carryall 500 2016 Maintenance And Service Manual

1
General Warnings

DISABLING THE VEHICLE

1. Engage park brake to lock wheels.
2. Turn the key switch OFF and remove the key.
3. Place the Forward/Reverse control in the NEUTRAL position.
4. In addition, chock the wheels if servicing or repairing the vehicle.
DISCONNECTING THE BATTERIES – ELECTRIC VEHICLES
1. Disable the vehicle. See Disabling the Vehicle on page 1-4.
2. Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to heed
this warning can result in a battery explosion or severe personal injury.
3. Disconnect the batteries, negative (–) cable first, as shown (Figure 1-1).
4. After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge.
CONNECTING THE BATTERIES – ELECTRIC VEHICLES
1. Ensure the Tow/Run switch is in the TOW position.
2. Connect the battery cables, positive (+) cable first.
3. Tighten battery terminals to 110 in·lb (12.4 N·m).
4. Coat terminals with Battery Terminal Protector Spray to minimize corrosion.
(–)
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or
connecting battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
2780
Page 1-4 2016 Carryall 500 and 700 Maintenance and Service Manual
(+)
Figure 1-1 Battery Cable Removal – Electric Vehicle
SAFETY