Table of Contents
Advertisement
5
Accelerator Pedal
6.
Inspect the pedal bushings (6) for wear and replace if worn.
ACCELERATOR PEDAL INSTALLATION
1.
Installation is reverse of removal procedure.
2.
Check return spring length and adjust if necessary (Figure 5-3, Page 5-2).
3.
Tighten pedal pivot bolt (1) and locknut (2) to 30 ft-lb (68 N·m).
4.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
2361
Figure 5-3 Accelerator Pedal Return Spring Length (To
Face Of Nut As Shown)
Page 5-2
2014 Carryall 295/XRT 1550 Maintenance and Service Manual
ACCELERATOR AND BRAKE PEDAL
ASSEMBLIES
Advertisement
Table of Contents
Troubleshooting
