Cdt Troubleshooting - Club Car Carryall 500 2016 Maintenance And Service Manual

CONTROLLER DIAGNOSTIC TOOL (CDT)

CDT TROUBLESHOOTING

In the event that the handset does not function as described in this manual, the following troubleshooting guide should
be studied and the referenced test procedures should be performed to troubleshoot the handset.
_
TROUBLESHOOTING GUIDE
SYMPTOM
Handset display screen is blank
TABLE CONTINUED ON NEXT PAGE
POSSIBLE CAUSES
Handset cord and/or adaptor is disconnected
Vehicle batteries – loose terminals or corrosion
Vehicle batteries – improperly wired
Vehicle batteries – batteries failed
Vehicle batteries – batteries not fully charged
Handset cord has failed
Handset cord adaptor has failed
CDT port (mounted under instrument panel
assembly) has failed
Contrast Setting is too light
Controller is in power-down mode (vehicle
unused and not charged for 72 hours)
Charger has been connected and charging for
more than 10 minutes
Loose vehicle wire harness connections
Speed controller malfunction
Handset has failed
2016 Carryall 500 and 700 Maintenance and Service Manual
CDT Troubleshooting
CORRECTIVE ACTION
See Plugging the CDT into the Vehicle on
page 11-2.
Section 14 — Batteries: IQ Plus Electric
Vehicles
Section 14 — Batteries: IQ Plus Electric
Vehicles
Section 14 — Batteries: IQ Plus Electric
Vehicles
Section 14 — Batteries: IQ Plus Electric
Vehicles
Test Procedure 1 – Handset Cord on page
11-28
Test Procedure 2 – Handset Cord Adaptor on
page 11-29
Test Procedure 3 – CDT Ports on page 11-29
See Backlight under HHP Settings menu
Connect charger or drive the vehicle a short
distance and reconnect the handset to the
vehicle
Disconnect charger, wait 30 seconds and
reconnect charger
Test Procedure 3 – CDT Ports on page 11-29
Section 12 — Electrical System
Troubleshooting: IQ Plus Electric Vehicles
Replace handset
11
Page 11-27