Club Car Carryall 500 2016 Maintenance And Service Manual page 416

23
Fuel Line
1. Pull out locking clip.
2. Push in on release tab.
3. While pushing in on release tab, pull fuel line off nipple.
3050
Figure 23-13 Fuel Line Connector – To Disconnect
FUEL LINE INSTALLATION
1. At fuel tank:
1.1. Clean the nipple on top of fuel pump module.
1.2. Push fuel line fully onto nipple until it locks in place (Figure 23-14, Page 23-18).
1.3. Engage locking clip by pushing in until fully seated and completely prevents the line from being pulled
off nipple.
2. At engine:
2.1. Connect fuel line to throttle body and secure with spring clamp. See following DANGER.
DANGER
• Ensure line is connected properly to avoid a leak that can cause a fire.
3. Clean spilled and remove any drained gasoline from the area.
4. Connect battery. See Side-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
See Top-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-5.
5. Place the Forward/Reverse handle in the NEUTRAL position, chock the wheels, and the neutral lockout switch in
the MAINTENANCE position (Figure 26-1, Page 26-1).
6. Turn the key switch to the ON position and check for fuel leaks. Repeat as necessary to build fuel pressure.
Any leaks found must be fixed.
DANGER
• Repair all fuel leaks before returning the vehicle to service.
7. If no leaks are found, place the neutral lockout switch in the OPERATE position (Figure 26-1, Page 26-1).
Page 23-18 2016 Carryall 500 and 700 Maintenance and Service Manual
3
2
1
FUEL SYSTEM: GASOLINE VEHICLES
1. Push fuel line onto nipple until it locks into place.
2. Push in locking clip until fully seated.
3051
Figure 23-14 Fuel Line Connector – To Connect
1
2