Polycom MGC-100 Getting Started Manual page 47

The Spans and Phones dialog box opens.
To define To remove a
a span span
The number used
to identify the
MCU
This dialog box is used to assign circuit identification numbers and the
dial-in phone number ranges to be used in dial-in conferences. Circuit
orders are automatically assigned to spans. If only one service provider is
used, define all the PRI lines here.
The dial-in phone numbers are allocated to the MCU by the service
provider (carrier) and should be obtained from the service provider.
Chapter 3 - Initial System Configuration
To define a dial-in phone
numbers range
To delete a
currently
defined dial-in
numbers range
To allocate
dial-in numbers
for Gateway
calls
To delete
allocated dial-in
numbers for
Gateway calls
List of dial-in
phone numbers
and their
ranges
allocated to the
Gateway
3-17