Setting Video Network Options; Figure 3-6.Video Network Screen - Polycom ViewStation EX User Manual

Setting Video Network Options

© Polycom, Inc. 2003
Use the Video Network screen to set the parameters for your
V.35/RS-449/RS-530 video network.
Figure 3-6. Video Network Screen
You can set the following options on this screen:
RS-366 Dialing—Enable this option if you want to call from the
system through the DCE connection to the far-end
videoconferencing system. Disable this option if you are using
your DCE to dial the call or if you have a dedicated connection
to the far site.
If the RS-366 Dialing option is enabled, you need to select
Dialing Speeds on this screen (see the following
Dialing Speeds
V.35 Ports Used—Select 1 if you are placing only 1-channel calls.
Select 1+2 if you are placing 2 x 56 Kbps or 2 x 64 Kbps channel
calls.
Dialing Protocol—RS-366 appears as the dialing protocol if the
RS-366 Dialing option is enabled. If the RS-366 Dialing option
is disabled, the Dialing Protocol does not appear.
Broadcast Mode—Enable or disable H.331 Broadcast Mode if
the system is connected to the network via satellite.
Note
section).
Chapter 3 - Initial System Setup
Selecting
69