HOLDEN WH II 2002 Series Owner's Handbook Manual page 62

Chapter 3
3-2
KNOW YOUR CAR
The front switch is used to electrically adjust
the height, the tilt and the movement of the
seat forwards and backwards.
The rear switch is used to electrically adjust
the angle of the back of the seat.
Adjustment to lumbar support and head
restraints are made manually.
Height and tilt adjust ( f ront switch)
Move the whole of the switch up or down to
move the whole of the seat up or down.
The switch can also be tilted to adjust the
seat angle. Tilt the switch up at the front to
tilt the front of the seat up. Similarly, tilt the
switch down at the rear to tilt the seat down
at the rear
Backwards/ f orwards ( f ront switch)
Move the whole of the switch forwards or
backwards, as required. The seat moves in
the same direction as the
Reclining back (rear switch)
Tilt the switch to adjust the angle of the back
of the seat. The seat back moves in the
same direction that the switch is tilted to.
Lumbar support
Move the wheel (on the door side of the
seat) to alter support given to the lower part
of your back.
Head restraint
This safety featUie is not intended as a headrest. !t is so!e!y for the reduction of whiplash
neck movement in a car accident.
To adjust the height of the head restraint, pull up or push down, as required. The upper
edge of the head restraint should be approximately at eye level, never at neck level.
In addition, several tilt angles are provided. Pull the head restraint forward. When the last
adjustment position has been reached, a further pull returns the head restraint to the
rearward, upright position.
FRONT SEAT
switch.
Forward/Up/Down/Tilt