HOLDEN WH II 2002 Series Owner's Handbook Manual page 24

Chapter 1
1-14
DASH
Customise mode
The trip computer uses in its calculations different calibration numbers. These figures
are pre-set for the standard car and do not have to be adjusted. However, each car does
vary due to tyre size, tolerances etc. and, therefore, the facility is provided to adjust each
figure for greater accuracy. Also provided in customise mode are different choices
about displays.
Cusiomise: how to entei calibiation numbers and choices
To enter customise
from OFF to ON. After entering customise mode, tap the MODE button to view each
calibration/choice or alter the settings as described below.
Calibration 1: Distance calibration
\
CA
100.0
If you wish to check/adjust this, line the car's front wheels against a highway kilometre
shield post BEFORE ENTERING CUSTOMISE MODE. Press both the_. and 'Y buttons
together when TRIP DIST is showing in the centre window (to zero the TRIP DIST).
Drive off to another shield post (between 10 km and 500 km) and stop with the front
wheels lined up again. Note the real distance between the shield posts and the distance
on the TRIP DIST display. If different, enter customise mode. The TRIP DIST is shown
in the centre window. Press the_. or 'Y buttons to adjust the centre display to show the
real distance indicated by the shield posts.
Note that the ieft display (the distance calibration %) automatically adjusts to the centre
display. The default distance calibration is 100.0%. The maximum it can be adjusted to
is 120.0%, the minimum is 80%.
Note that altering the distance calibration does not affect the odometer.
Press the MODE button to go to the next calibration
Calibration 2: Fuel flow calibration number
If you wish to check!adjust this, work outthe following BEFORE ENTERING CUSTOMISE
MODE. Press both the _. and 'Y buttons together when FUEL USED is showing in the
right hand window (to zero the FUEL USED). Then, for at least five consecutive fuel fills,
record the total litres added (but no more than 500 litres), according to the service station
fuel
!f this is different to the FUEL USED readinq, enter customise mode and
tap the MODE button once, to show "CAL 2". The
hand display. Press the_. or
total fuel used according to the service station fuel bowser.
Note that the left display (the fuel flow calibration %) automatically adjusts to the right
display. The default fuel calibration is 100.0%. The maximum it can be adjusted to is
120.0%, the minimum is 80%.
Press the MODE button to go to the next
TRIP COMPUTER cont.
mode, press and hold the MODE button while the ignition is turned
DIST
1Q. 0
km
FUEL- USED is shown on the right
hand display
number.
choice.