HOLDEN WH II 2002 Series Owner's Handbook Manual page 114

Side turn signal (5 watts)
Grasp the lens at the rear, push forwards
and pull away from the car body (to expose
approximately 4 em or wiring). Separate
the bulb holder from the lens assembly by
first rotating the bulb holder anti-clockwise.
The bulb pulls straight out of the bulb
holder. Insert new bulb into bulb holder.
Install bulb holder into lens housing. Note
that bulb holder only fits into lens housing
one way. Therefore, keep turning bulb
holder clockwise until it fits into place and
can be tightened.
When re-inserting the light, feed the wiring
back into the car body, then locate the front
of the housing into the body before pushing
the rear inwards.
Check light operation.
Rear high stop light ( 18 watts)
From inside the boot, reach under the stop light and twist anti-clockwise to remove the
bulb holder.
Bulb pulls straight out of bulb holder.
Install new bulb into bulb holder, feed the wiring back into the cavity and refit bulb holder
back into stop light.
Check light operation.
Number plate (5 watts)
Push the tab on the left side of the lens to
the right and pull the lens assembly
downwards.
Turn the bulb holder anti-clockwise to
remove from the lens assembly. Pull the
bulb straight out of the bulb holder.
Push new bulb into bulb holder. Install bulb
holder into lens. Feed the wiring back into
the cavity, fit lens into body, right side first.
Push lens housing into place.
Check light operation.
Cornering lights, if fitted (21 watts)
Reach underneath the bumper bar, rotate
the bulb holder anti-clockwise and remove.
Push in and turn the bulb to remove from
the bulb holder.
Install new bulb into bulb holder, refit bulb
holder back into cornering light.
Check light operation.
BULB REPLACEMENT cont.
Chapter
6
EMERGENCIES
6-19