HOLDEN WH II 2002 Series Owner's Handbook Manual page 22

Chapter 1
1-12
DASH
Additional displays
Additional displays can be activated using customise mode, refer over the page.
DISTANCE TO ARRIVAL, TIME TO ARRIVAL and REMAINING FUEL are turned on
and ott as a set, they cannot be individually activated.
When the displays are activated, press the MODE button to scroll through all the Trip
Computer displays. There are now 4 sets of displays, instead of 3. The new displays
are slotted between the TRIP display and the DISTANCE TO EMPTY display.
Customise mode can be used to deactivate the displays, if required.
It TIME TO ARRIVAL is turned ott using customise mode, it can still be temporarily
turned on by the following quick method:
Press MODE button until the TRIP distance is shown, press the .._ and 'Y
together to zero the trip display, then increase the distance up by pressing the.._ button.
However, when the trip distance reaches zero the function is turned ott again. Use the
customise mode to permanently turn the displays on.
TIME TO
ARRIVAL
Time to arrival
Shows trip time to arrival in
hours and minutes, based
on DISTANCE TO
ARRIVAL.
Trip B
When the above set of windows are turned on (using the customise mode) and are
showing on the display, hold the MODE button down tor two seconds. Now, instead of
the above displays, the trip computer shows:
8:0
Press the MODE button to view your displays. You now have two different sets of trip
displays counting, your original set of trip displays (labelled 11A11 while
and a new set of trip displays, labelled 11811• This is useful on a long trip, as Trip 8 can
be reset 1at the beginning of the journey and then locked away (by pressing the MODE
button tor 2 seconds when 11Trip 811 is shown). TIME TO ARRIVAL, DISTANCE TO
ARRIVAL and REMAINING FUE L are shown on the display, but Trip 8 is still counting
away in the background and the original trip display can be used tor short distances
during the journey. Trip 8 can be viewedJat any time by pressing the MODE button tor
2 seconds when DISTANCE TO ARRIVAL is shown.
TRIP COMPUTER cont.
DISTTO
ARRIVAL
Distance to arrival
At the start of a trip
estimate your distance to
arrival (from maps, road
signs etc.). Tap the .A. or 'Y
buttons until the display
shows your estimated trip
distance. When you drive
ott the computer constantly
updates your time to
arrival, based on changing
.rJ ... :, ; """"",... C"
, __
UIIVIII� i:>tJv<:>Ui:>.
use the .A. or 'Y buttons to
adjust the kilometres any
time this display is shown.
9
80
REMAINING
k m
F U EL
Remaining fuel
Shows the litres of fuel lett
in the fuel tank, rounded to
the nearest 5 litres.
When fuel level is low 11L 0 11
is displayed.
VI"\
I a l"" .n n
I VU VUI o
0
9
9.
k m
buttons
YO
L
2. J 2
11
811 is turned on)