HOLDEN WH II 2002 Series Owner's Handbook Manual page 103

Chapter 6
6-8
EMERGENCIES
15. Replace the centre cap: note the two notches on the underside of the cap. These
must be lined up with the same slot provided for removing the wheel trim. Push on
by hand.
16. Stow all tools and flat tyre as shown on earlier pages.
Notes:
When re-installing the jack, insert the nut end in first, with the nut end pointing
•
towards the front of the car.
Remember to unhook the spare wheel cover before closing the boot.
•
To reduce movement of the spare wheel in the load area, the centre nut should
•
be tightened to between 2 to 3 Newton metres (very tight "finger" tight).
17. Remember to get the tyre repaired as soon as possible.
CAUTION:
As soon as possible after changing a wheel, you should have the wheel nuts tightened
with a torque wrench to between 1 00 and 125 Newton metres. Wheel nuts should be
tightened evenly to the correct torque in the sequence shown, as wheel nuts which have
not been tightened properly could eventually allow the wheel to come off while the car
is moving!
FLAT TYRE cont.