Interior dome (10 watts)
Insert a fine bladed screwdriver in the slot
in the centre of the lens and gently lever
out.
Remove the bulb by bending the contacts
out from the bulb while pulling the bulb
down.
Install the new bulb and ensure that both
ends of the bulb are firmly in place.
Reinstall the dome lens and push back into
place with your hand.
Front reading (8 watts)
The front reading lights, if fitted, are part of
the dome light assembly. To replace a
reading light bulb, first remove the lens of
the dome light, as shown above.
Then, remove reading light cover plates by
gently pulling the thin tab down.
Pull out the bulb by hand.
Install the new bulb and ensure that both
ends of the bulb are firmly in place.
Reinstall the cover plates (large end in first)
and click firmly into place.
Reinstall the dome lens and push back into
place with your hand.
Footwell lights (2. 7 watts)
Front footwell light bulbs are located in holders which are a "twist" fit into the right and
left hand side trim of the instrument panel.
To replace a bulb, pull straight out. Bulbs are a "push" fit into the holder and are fitted
with a green cover. When replacing a bulb ensure that the green cover is installed onto
the bulb.
BULB REPLACEMENT cont.
Chapter
6
EMERGENCIES
6-21