HOLDEN WH II 2002 Series Owner's Handbook Manual page 26

Chapter 1
1-16
DASH
Service Due
A service reminder message is built into the trip computer.
The reminder message first appears 1 ,000 km before the service is actually due, giving
you time to arrange for the service to be carried out. The message is shown on the Trip
computer for 1 0 seconds whenever the car's ignition is switched ON or OFF, until the trip
computer is reset. When the service is overdue, the message flashes for 1 0 seconds
when the ignition is turned ON or OFF.
SERV 1500 km shows 'Nhen the car has trave!!ed 500 km since it was bui!t.
e
• SERV 10000 km shows when the car has travelled 9,000 km since it was built.
SERV 20000 km shows when the car has travelled 19,000 km since it was built.
•
SERV 30000 km shows when the car has travelled 29,000 km since is was built etc.
•
The trip computer will be reset for you by your Holden Dealer when you take the car in
to be serviced. If, for some reason, you wish to reset the reminder message yourself,
follow the sequence below:
1. Turn the ignition OFF.
2. Hold down the trip computer .A and T buttons together.
3. Turn the ignition ON while still holding down both buttons.
4. After approx. 3 seconds, release both buttons.
5. Press and release the MODE button; the service due screen appears on the
display.
6. Press and hold both .A and T buttons for approx. 3 seconds until a beep is heard.
7. Release both buttons.
8. Turn ignition OFF.
This message is calculated only by distance. Remember that if you are driving
infrequently, special servicing may be required, refer Chapter 12.
Trip computer notes:
• If the wrong buttons are accidentally pressed, causing the window to show other than
normal, turn the ignition OFF then ON again when the car is standing still.
Two warning iights are iinked to the trip cornputer displays:
1) When the fuel tank level first drops below 81itres (approx.), the DISTANCE TO
EMPTY display is automatically shown for 10 seconds, after which the trip
computer returns to its previous display.
2) When the OVERSPEED warning symbol is first shown, the OVERSPEED trip
computer display is automatically shown for 10 seconds. This is to show what your
pre-selected speed is and allow you to adjust it if required. After 10 seconds, the
trip computer returns to its previous display.
Some displays change the units of measurement over time. For example, the TIME
•
TO ARRIVAL shows 10 minute units above 2 hours to arrival, shows 5 minute units
below 2 hours to arrival and shows 1 minute units below 1 0 minutes to arrival.
Note that the flashing light above the switches for the trip computer is for the security
•
system, refer Chapter 2 "Locks".
Higher luxury level cars have a personal identity key system (fully explained in
•
Chapter 2) which remembers different settings used by different keys. If your car is
fitted with this system, the trip computer remembers your last selected settings.
When the ignition is turned on with your key, your last set of displays and overspeed
settings are shown.
[!)
This symbol, shown in the left window, indicates a fault in the trip computer.
TRIP COMPUTER cont.