HOLDEN WH II 2002 Series Owner's Handbook Manual page 108

3.
Attach one end of the RED jumper lead to the positive terminal of the booster battery
(identified by a red colour,
positive terminal of the flat battery.
4.
Attach one end of the BLACK jumper lead to the negative terminal of the booster
battery (identified by a black colour, - or N) and the other end of the BLACK jumper
lead to a solid stationary, metallic point on the engine of the car with the flat battery.
DO NOT CONNECT DIRECTLY TO NEGATIVE TERMINAL OF THE BATTERY.
5.
When making all connections take care that the jumper lead clamps do not touch
each other. Also, ensure that jumper leads are not on or near pulleys, fans or other
points that will move when the engine is started.
6.
Start the engine in the car with the good battery and run the engine at a moderate
speed. Then start the engine with the flat battery.
7.
Leave the engines running while removing the jumper leads- in the exact reverse
order they were installed. While removing each clamp, take care that it does not
touch any other metal while the other end remains attached.
8. Replace any battery covers.
Note that your radio may require input of the PIN, refer Chapter 1.
FLAT BATTERY cont.
or P) and the other end of the RED jumper lead to the
+
-o
Flat Battery
Booster Battery
Chapter 6
EMERGENCIES
0 Make last connection to
a solid, stationary, metallic
point on the engine
6-13
I