HOLDEN WH II 2002 Series Owner's Handbook Manual page 25

Choice: Skip DISTANCE TO ARRIVAL
ARRIVAL
This is the choice to activate an additional set of displays: TIME TO ARRIVAL,
DISTANCE TO ARRIVAL and REMAINING FUEL. These displays are explained on the
previous pages.
Press .A or T button to select YES or NO.
Press the MODE button to go to the next calibration number.
Calibration 3: Adjust DISTANCE TO ARRIVAL default setting
CAL 3
The DISTANCE TO ARRIVAL can be reset (when not in customise mode) by pressing
the .A and T buttons together. The distance resets to 500 km, which is the default
setting. When in customise mode, the default setting can be altered up or down by
pressing .A or T buttons, helpful to quickly recall a regularly travelled trip.
Press the MODE button to go to the next choice.
Choice: Underspeed chime
OFF
OVERSPEED provides a chime when your travelling speed exceeds OVERSPEED,
and another chime when travelling speed again drops below OVERSPEED chosen
speed. Customise mode gives a choice about turning the second chime, the "underspeed"
chime off or on. Press .A or T button to turn underspeed chime OFF or ON.
Then press MODE button to end Customise mode.
Customise mode ends automatically if car speed exceeds 1 0 km/h or if the ignition is
turned off and on.
TRIP COMPUTER cont.
N
ARRIVAL
0 0
���JfL
s
SOU ND
Chapter 1
DASH
km
USP D
1-15
I