HOLDEN WH II 2002 Series Owner's Handbook Manual page 115

Chapter 6
6-20
EMERGENCIES
Rear turn signal (21 w), stop/tail (21 /5 w)
Open boot.
1 .
From outside the boot, remove the two
2.
screws attaching the rear quarter light
assembly to the body.
Pull the rear quarter light assembly
3.
locating pegs on the side of the light
assembly snap free from the clips. While
holding the light assembly, turn and
remove the appropriate bulb holder.
Remove bulb from holder by pushing in
3.
and turning anti-clockwise.
The turn signal bulb must have orange
glass, the others must have clear giass.
Insert new bulb into bulb holder and refit bulb holder into light housing, ensuring that
4.
the holder locks securely in place.
Ensure that the rear quarter light clips are seated correctly. Fit the light housing to
5.
the body, ensuring that the locating pegs snap into the clips and install and tighten
attaching nuts to the correct torque: 3 to 4
Check rear light operation.
6.
1 . Open boot lid and pull away carpet trim
from area.
Inside boot lid, twist to release bulb
2.
holder from behind light assembly.
the buib, pus
anti-clockwise.
Insert new bulb and reinstall bulb holder.
4.
Replace carpet trim.
5.
Check light operation.
6.
Fog lights, if fitted (27 watts)
Reach underneath the bumper bar, rotate
the bulb holder anti-clockwis-
Push in and turn the bulb to remove from
the bulb holder.
Install new bulb into bulb holder, refit bulb
holder back into cornering light.
Check light operation.
BULB REPLACEMENT cont.
in and tum
e and remove.
Nm.