Table of Contents
Advertisement
a. Extend the server from the rack.
b. Remove the server from the rack.
4.
Remove the access panel.
5.
If the Smart Storage battery is not installed, do one of the following:
•
Remove the air baffle.
•
If installed on LFF models, remove the midplane drive cage.
6.
Locate any NVDIMMs already installed in the server.
7.
Verify that all LEDs on any installed NVDIMMs are off.
8.
Install the NVDIMM.
9.
If it is not already installed, install the Smart Storage battery.
10. Install the access panel.
11. Slide or install the server into the rack.
12. Connect each power cord to the server.
13. Power up the server.
14. If required, sanitize the NVDIMM-Ns. For more information, see NVDIMM sanitization.
Configuring the server for NVDIMMs
After installing NVDIMMs, configure the server for NVDIMMs. For information on configuring settings for NVDIMMs, see
the HPE 16GB NVDIMM User Guide on the Hewlett Packard Enterprise website (http://www.hpe.com/info/nvdimm-
docs).
The server can be configured for NVDIMMs using either of the following:
Hardware options installation
87
Advertisement
Table of Contents
