Installing A Universal Media Bay - HPE ProLiant DX380 Gen10 User Manual

19. Reinstall the riser.
20. Connect peripheral devices to the server.
21. Connect the power cord to the server.
22. Connect the power cord to the power source.
23. Power up all peripheral devices.
24. Power up the server.
Array and controller configuration
During the initial provisioning of the server, you must configure the controller using the Smart Array configuration utility
in UEFI System Utilities.
After the initial provisioning of the server, you can use any of the following options to configure the arrays and controllers:
• UEFI System Utilities
• HPE MR Storage Administrator
• StorCLI
HPE MR Storage Administrator and StorCLI are available in the Service Pack for Proliant (SPP).
For more information about using each configuration utility, see the documentation for the configuration utility.
NOTE:
• Any RAID configuration created for the HPE Smart Array MR controller is not available to HPE Smart Array SR
controllers.
• The message "Data Protection disabled" in the logical drive properties can be ignored as it refers to a feature not
currently supported by the HPE MR Storage Administrator product.

Installing a Universal Media Bay

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
Hardware options installation
96