Table of Contents
Advertisement
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots
have either an expansion slot cover or an expansion board installed.
2.
Power down the server.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Do one of the following:
•
Extending the server from the rack.
•
Removing the server from the rack.
5.
Remove the access panel.
6.
Removing the air baffle or midplane drive cage.
7.
For full-length cards that require support, install retention clips:
a. Remove the air diverters from the air baffle.
b. Install the appropriate retention clip onto the air baffle.
Install the clip that supports your configuration. Primary, secondary, and tertiary positions are shown.
Hardware options installation
134
Advertisement
Table of Contents
