Using The Web Interface; Logging On To The Web User Interface; Setting The System Notification - Christie HS 2K Series User Manual

Using the web interface

To control the projector through the web interface, do the following:
1. Start up the web browser on your computer or mobile devices.
2. Enter the IP address set on the projector into the URL of the web browser.
3. Enter the user name and password to login. After a successful login, you can control the
projector over the web interface.

Logging on to the web user interface

Log into to the web user interface by following the steps below.
1. Connect the projector to AC and power it on.
2. When the network is available, connect the projector and computer to the same network.
a. To check the projector address in a wired network, select Menu > Configuration >
Communications > LAN > IP Address.
b. To check the projector address in a wireless network, select Menu > Configuration >
Communications > WLAN > Default Gateway.
3. If the network is unavailable, connect the projector to the computer with an RJ45 cable.
a. Set the Default Gateway and Subnet Mask of the computer to match the projector.
b. Set the IP address of the computer to match the first three numbers of the projector.
For example, if the projector IP address is 192.168.000.100, set the computer IP address
to 192.168.000.xxx, where xxx is not 100.
4. Open a web browser and type the projector address in the browser address bar.
5. In the Username field, type the username.
The default username is admin.
6. In the Password field, type the password.
The default password is admin.
7. Click Login.

Setting the system notification

Configure the Simple Network Management Protocol (SNMP) settings for receiving notifications
from the system directly to the email. SNMP provides network administrators with a common way
to manage their network devices from a single remote location. Administrators can use the SNMP
interface to query a number of devices to see their current status or configuration. Operators can
change configuration values and configure trap notifications to be sent when certain events occur
(for example, loss of signal, power state change, and so on).
Emails are sent to the mail server configured in the projector settings. Up to two user email
accounts can be selected. Important information regarding the event is located in the body content
of the email.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring communications
58