Setting The Ac Power; Setting The Time For Auto Shutdown; Setting The Sleep Timer; Enabling High Altitude Setting - Christie HS 2K Series User Manual

Setting the AC power

Enable or disable to power on the projector directly.
1. Select Menu > Configuration > Power Management > AC Power On.
2. To toggle, select ENTER.

Setting the time for auto shutdown

Set up a time for automatically turns off the projector after no signal is detected for a preset
number of minutes. If an active signal is received before the projector powers down, the image is
displayed.
1. Select Menu > Configuration > Power Management > Auto Shutdown.
2. Select the appropriate time to automatically turn off the projector when there is no signal.
3. To confirm the selection, select ENTER.

Setting the sleep timer

Set up a time for automatically power off the projector, after it has been on for a specified amount
of time.
1. Select Menu > Configuration > Power Management > Sleep Timer.
2. Select the appropriate time to automatically turn off the projector.
3. To confirm the selection, select ENTER.

Enabling high altitude setting

Enable high altitude mode when altitudes >/= 2000 m. The fan operates at high speed to ensure
sufficient air flow for high altitudes; however, the noise level of the projector is increased.
1. Select Menu > Configuration > High Altitude.
2. To toggle, select ENTER.

Setting the projector communication

Enable the receivers and the wired keypad to communicate with the projector from the remote. The
front and top IR sensors receive transmissions from the IR remote. Keep the transmission path to
these sensors unobstructed for uninterrupted communications with the projector.
1. Select Menu > Configuration > IR Control.
2. To enable the top IR sensor, select Top.
3. To confirm the selection, select ENTER.
4. To enable the front IR sensor, select Front.
5. To confirm the selection, select ENTER.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
55