Configuring The Hdmi Setting; Configuring The Hdmi Output - Christie HS 2K Series User Manual

• Normal—No functional restrictions but longer delay time.
• 2D Ultra—Reduces latency in 2D mode but sets restrictions when warping the image.
2D Ultra does not support 3D, 4K timing, input timings outside the range of 30fps to 120fps, PIP/PBP
mode, and image freeze.
3. To confirm the selection, select ENTER.

Configuring the HDMI setting

Enable or disable the Extended Display Identification Data (EDID) for HDMI 2.0 to play videos from
hardware devices, such as DVD players.
The most commonly used HDMI versions are HDMI 1.4 and 2.0, with differences in bandwidth.
HDMI 1.4 has limited rate of 2K. DWU880-GS, DWU880A-GS, DWU1100-GS, DWU1100A-GS,
DWU1300-GS, and DWU1300A-G projectors are compatible with both HDMI 1.4 and HDMI 2.0.
When the projector is connected to a hardware device supporting HDMI 1.4 only, disable the EDID
for HDMI 2.0 to play the videos properly.
1. Select Menu > Input Switching & PIP > EDID.
2. Select the HDMI 1 or HDMI 2 item where you want to enable EDID.
3. Set 1.4 or 2.0.
4. To confirm the setting, select ENTER.

Configuring the HDMI output

Set the default HDMI output port.
1. Select Menu > Input Switching & PIP > HDMI Out put.
2. Select HDMI 1 or HDMI 2 as the HDMI output.
3. To confirm the setting, select ENTER.
If multiple projectors are connected to each other in a daisy chain, the HDR signal output is
determined by the first projector and PC handshake.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring input settings
73