Installation Safety And Warning Guidelines; Laser Safety Precautions - Christie HS 2K Series User Manual

Installation safety and warning guidelines

Read all safety and warning guidelines before installing the projector.
Warning! If not avoided, the following could result in death or serious injury.
• High leakage current present when connected to IT power systems.
Caution! If not avoided, the following could result in minor or moderate injury.
• ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
• Only Christie-qualified technicians are authorized to use the tools provided in the toolbox.

Laser safety precautions

This projector has been classified as Class 1 Laser Product - Risk Group 3 according to IEC 60825-
1:2014 and IEC 62471-5:2015 standard. Read all safety and warning guidelines before installing or
operating the projector. It complies with 21 CFR 1040.10 and 1040.11 except for conformance as a
Risk Group 3 LIP as defined in IEC 62471-5:Ed. 1.0. For more information see Laser Notice No. 57,
dated May 8, 2019. IEC 60825-1:2014: CLASS 1 LASER PRODUCT - RISK GROUP 3.
Warning! If not avoided, the following could result in death or serious injury.
• LASER RADIATION HAZARD! This projector has a built-in Class 4 laser module. Never attempt to
disassemble or modify the laser module.
• Any operation or adjustment not specifically instructed in the User manual creates the risk of
hazardous laser radiation exposure.
• Do not operate the product without all of its covers in place.
• Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
• Only Christie-qualified technicians who are knowledgeable about the hazards associated with
laser use, high-voltage, and high temperatures generated by the product are authorized to
assemble, install, and service the Christie Laser Projection System.
• Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage. Class 1 laser product of IEC/EN 60825-1:2014 and Risk Group 3
according to IEC 62471-5:2015.
• Use caution when using the remote control in front of the projection lens when starting the
projector.
• Avoid the user of optical aids inside the beam such as binoculars or telescopes.
• Do not stare into the beam, RG3 IEC 62471-5:2015.
• Use a ceiling mount to mount the product to restrict access to the light beam.
• For DWU23-HS and DWU23A-HS no direct exposure to the beam is permitted, RG3 IEC 62471-
1:2015 when an interchangeable lens with throw ratio greater from 1.5-2.0:1 is installed.
• For DWU19-HS, DWU19A-HS, DWU15-HS and DWU15A-HS no direct exposure to the beam is
permitted, RG3 IEC 62471-1:2015 when an interchangeable lens with throw ratio greater from
2.0-4.0:1 is installed.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Introduction
10