Inhalation; Waste Disposal - Stratasys Objet260 User Manual

Objet260 User Guide

Inhalation

Vapors from printing materials can be irritating to the respiratory system. If
respiratory irritation occurs, expose the victim to fresh air immediately.
➢ If the victim has stopped breathing, perform artificial respiration or
➢ Seek medical attention immediately.
➢ Keep the victim warm but not hot.
➢ Never feed anything to an unconscious person.
➢ Oxygen should be administered by authorized personnel only.
Waste Disposal
Fully cured 3D prints can be disposed of as ordinary office trash. However,
special care is required when handling printer waste (uncured printing
material).
Printing Materials
➢ When removing the waste cartridge/container from the printer, wear
➢ To prevent liquid waste from splashing into the eyes, wear safety goggles.
➢ Liquid waste from the printer is classified as hazardous industrial waste.
➢ Empty model-material and support-material cartridges contain residue of
➢ Do not attempt to reuse empty cartridges, and do not puncture them.
➢ Dispose of used cartridges and waste containers in accordance with local
➢ Discard contaminated clothing, shoes, empty containers, etc., in
DOC-37004 Rev. J
cardiopulmonary resuscitation.
neoprene or nitrile gloves.
Therefore, printing-material waste must be packaged and disposed of in a
manner that prevents human contact with it and contamination of water
sources.
their contents. Some leakage of this residue may occur through the broken
cartridge seal. Therefore, handle and store empty cartridges with care.
regulations.
accordance with any applicable regulations.
2 Safety
2-9