Stratasys Objet260 User Manual page 227

Objet260 User Guide
The waste container consists of a plastic container inside a cardboard box.
You typically dispose of the entire waste container—including the box.
Therefore, you must assemble a new box and insert a new plastic container
before you can install it in the printer.
Replacement boxes, plastic containers, and sealing caps are supplied in
the printer start-up kit and in the preventive-maintenance kit.
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Fold a new waste bag—so it fits in the box—and insert the bag's screw-
To replace the waste container:
1. Push the door of the lower printer compartment to open it.
2. Push in the top-center of the door to release the latch and open the door.
3. Carefully slide out the waste container to remove it from the printer.
4. Place the new waste container next to the full container.
DOC-37004 Rev. J
sections.
connector into the hole in the top of the box.
Note: Do not close the box until you connect the waste drain tube from the
printer.
Figure 6-127 Waste container under the printer
Figure 6-128 Waste container removed from the printer
6 Operating and Maintaining the Printer
6-91