Stratasys Objet260 User Manual page 216

Objet260 User Guide
13. U se the UV lamp clamp to insert the lamp into place in the UV reflector.
14. U sing a 2.5-mm hex key, secure the clamp to the UV reflector, and continue
15. I nspect the new UV reflector, and make sure that a black strip is attached to
16. D iscard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
DOC-37004 Rev. J
Figure 6-117 Pushing the UV lamp into place
with step .
25
Figure 6-118 Attaching the UV lamp clamp
the inside of it. If not, install one—on the side of the reflector opposite (not
next to) the print block.
Note: Extra black strips are included in the printer Start-Up Kit. If
necessary, you can remove the black strip from the old reflector and install it
in the new reflector (as long as the black paint has not faded).
6 Operating and Maintaining the Printer
6-80