Stratasys Objet260 User Manual page 228

Objet260 User Guide
5. Unscrew the cap securing the waste drain tube and connect it to the new
6. Close the full container with the cap supplied with the new waste container.
7. Close the new waste container box.
8. Position new the waste container in the printer.
9. Close the compartment door.
Dispose of the full waste container in accordance with environmental and
safety requirements.
DOC-37004 Rev. J
container.
Note: The sealing cap contains an inner stopper that prevents leakage
when the cap is tightened. Do not be concerned that air can still flow
through the opening on the top of the cap, since the inner stopper seals the
waste container.
Figure 6-129 Waste container sealing cap
Note: Make sure that the waste drain tube is not crimped or twisted, and
that it is not pinched by the container.
6 Operating and Maintaining the Printer
6-92