Installing The New Head - Stratasys Objet260 User Manual

Objet260 User Guide
Installing the New Head
14. I nspect the replacement head, and make sure that the O-ring seals are in
15. G ently insert the replacement head into the vacant slot in the print block,
DOC-37004 Rev. J
Figure 6-80 Making sure the O-rings are not stuck to the print block
place (see Figure 6-79 on the previous page).
and push the print-head driver card into its socket.
Note: Make sure to insert the head with the driver card facing its socket, in
the rear of the print block.
Figure 6-81 Inserting the print-head driver card into its socket
6 Operating and Maintaining the Printer
6-60