Stratasys Objet260 User Manual page 219

Objet260 User Guide
DOC-37004 Rev. J
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Note: The mode currently being checked appears in the lower-left corner
of the printer interface.
Figure 6-123 Status during UV lamp check
After replacing a UV lamp, it is recommended that you calibrate its power.
The next screen allows you to continue to the UV Calibration wizard (see
"Testing and Calibrating the UV Lamps" on page 6-64).
Figure 6-124 Calibration selection screen
6 Operating and Maintaining the Printer
6-83