Stratasys Objet260 User Manual page 205

Objet260 User Guide
External UV Meter
The following steps apply when using a stand-alone UV meter. This section
does not apply when using the Stratasys UV sensor box connected to the
printer.
1. When the following screen appears, open the printer and place the UV
2. Lead the cable out of the printer so that you can close the printer, and tape
3. Close the printer, while checking that the sensor does not move out of
4. Set the UV meter to measure mJ/cm2.
5. Set the range on the meter to 2,000.
DOC-37004 Rev. J
sensor (probe) at the rear edge of the tray, in the center.
Figure 6-96 Sensor placement screen
it down to make sure that it does not interfere with the moving print block.
Figure 6-97 Correct UV-sensor placement
position.
6 Operating and Maintaining the Printer
6-69