Stratasys Objet260 User Manual page 179

Objet260 User Guide
3. When instructed to do so, place the transparency on the build tray—next to
4. Make sure that the transparency sheet is lying flat, and tape it to the tray.
5. Close the printer cover.
6. In the wizard screen, select the check box to confirm that the transparency
7. Open the printer and remove the transparency.
DOC-37004 Rev. J
the left and rear edges of the tray, as shown in the following figure.
Figure 6-49 Positioning the transparency on the build tray
sheet is secured to the build tray, and click Next.
When you click Next, the printer prints the head alignment test on the
transparency. When printing is finished, the following screen appears.
Figure 6-50 Head Alignment wizard—steps 7–9
The transparency sheet is printed with sets of vertical lines in seven
columns, each showing the results from a different print head.
6 Operating and Maintaining the Printer
6-43