Stratasys Objet260 User Manual page 195

Objet260 User Guide
11. L oosen the screws on the door of the compartment protecting the
12. P ull the print-head driver card out of its socket so that the head is free (A),
13. M ake sure that along with the head, you remove the two rubber O-ring
Important
If the seals are not removed with the head, they are probably stuck to the
print block housing. If so, remove them.
DOC-37004 Rev. J
print-head driver cards (A), then pull and lift up the door (B).
Figure 6-77 Opening the print-head compartment
and remove it from the bottom of the print block (B).
Figure 6-78 Releasing the print-head driver card to remove the head
seals.
Figure 6-79 O-ring seals on the print head
6 Operating and Maintaining the Printer
6-59