Powering Up The Camera; Status Light; Ip Button - LEGRAND VADDIO RoboSHOT 30E-M Complete Manual

Powering up the camera

Connect camera power. The camera will initialize and move. This will take a few seconds. When an
image is available, the camera is ready to accept control information.

Status light

The light in the camera's base indicates its current state.
Purple – Standby mode or booting
n
n Yellow – Firmware update is in progress
n White – Camera is active
Caution
Do not remove power or reset the camera while the status light is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the light is off.

IP button

Use the button on the back of the camera to do these things:
Display the camera's IP and MAC addresses in the video output: Press the button momentarily.
n
Press it again to dismiss the information display.
Restore factory default settings: Disconnect the network cable. Then press and hold the IP button
n
while reconnecting the cable. Continue to hold the button for about 10 seconds.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
8