Operating The Camera; Stopping Or Resuming Video; Managing The Camera Ready State - LEGRAND VADDIO RoboSHOT 30E-M Complete Manual

Operating the camera

In most cases, the remote provides all the controls you need to operate the camera. Refer to the user
guide for the remote, which is available on the same page of the website as this manual.
By default, the operator's page of the web interface is not available. The administrator must set a
password for the user account, or enable guest access; this provides access to the operator's page
only. The web interface is available on the Vaddio Device Controller touch panel (if your installation uses
one) or from a web browser.
The operator's Camera page provides most of the same controls as the remote:
n Pan, tilt, zoom, or return to home position
Stop or resume transmitting live camera video (video mute)
n
Put the camera in standby or bring it back to the ready state
n
Move to camera presets, if any have been stored
n
Select a custom lighting adjustment, if any have been stored
n

Stopping or resuming video

Use the mute button to temporarily stop video from the camera without placing it in standby. Remember
that the video mute button does not mute the room's microphones, conference phone, or your computer's
microphone. In video mute mode, the camera transmits blue or black video, with a message that the
video is muted.

Managing the camera ready state

Use the Standby button to switch between low-power (standby) and ready states.
In standby mode, the screen presents the message "Device is in standby." On entering standby mode,
the camera pans 90° from center and 30° downward.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
32