Initial device set-up
Vaddio cameras have a web interface for initial device set-up, administrative control, and operation.
When any Vaddio product is shipped from the factory, the administration and operation areas of the web
interface are not available. You will need to set the admin password to access the full web interface.
Initial device set-up using the Vaddio Device Controller
The Vaddio Device Controller is a stand-alone tablet device for working with Vaddio products' web
interfaces.
To complete the initial device set-up with the Vaddio Device Controller:
1. Connect the touch-panel to the network on the same subnet as the products you need to work with –
for example, connect both to the same PoE+ switch.
2. Go to the touch-panel's Configuration page (gear icon) and select Scan.
3. Locate the device you need to work with, and select Use.
4. Select Exit to leave the Configuration page and open the device's web interface.
5. Set the admin password.
If the Vaddio Device Controller does not find the camera, verify that the Vaddio Device Controller and
camera are connected to the same subnet.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
9