Table of Contents
Advertisement
Powering up the camera
Connect camera power. The camera will initialize and move. This will take a few seconds. When an
image is available, the camera is ready to accept control information.
Status light
The light in the camera's base indicates its current state.
Purple – Standby mode or booting
n
n
Yellow – Firmware update is in progress
n
White – Camera is active
Caution
Do not remove power or reset the camera while the status light is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the light is off.
IP button
Use the button on the back of the camera to do these things:
Display the camera's IP and MAC addresses in the video output: Press the button momentarily.
n
Press it again to dismiss the information display.
Restore factory default settings: Disconnect the network cable. Then press and hold the IP button
n
while reconnecting the cable. Continue to hold the button for about 10 seconds.
Next steps
The camera is now ready to configure and use. This information is available in the Complete Manual for
the RoboSHOT 30E-M PTZ Camera.
Vaddio is a brand of Legrand AV Inc. ·
Europe, Middle East, Africa:
av.emea.vaddio.support@legrand.com
Vaddio is a registered trademark of Legrand AV Inc. Microsoft and Microsoft Teams are trademarks of the Microsoft group of
companies. All other brand names or marks are used for identification purposes and are trademarks of their respective owners. All
patents are protected under existing designations. Other patents pending.
©2023 Legrand AV Inc.
Installation Guide for the RoboSHOT 30E-M PTZ Camera
www.legrandav.com
· Phone 800.572.2011 / +1.763.971.4400 · Fax +1.763.971.4464 · Email
· All other regions:
av.vaddio.techsupport@legrand.com
Advertisement
Table of Contents
