Setting Other System Behaviors - LEGRAND VADDIO RoboSHOT 30E-M Complete Manual

Setting other system behaviors

S , G
YSTEM PAGE ENERAL TAB
The following settings are available on the System page:
Auto Standby – Enable to automatically set the camera in standby (low-power) mode when not
n
connected to a computer.
LED On – Enabled by default. If desired, the status light can be turned off.
n
LED On in Standby – Enabled by default. Disable to turn off the status light when the camera is in
n
standby mode.
n Point Light Compensation – Disabled by default. Reduces the intensity of small, extremely bright
areas (point light sources) that would otherwise swamp the camera with light and make it difficult to
see details in areas with less intense lighting.
Anti-flicker Filter – Enabled by default; reduces flicker. Most noticeable if AC mains power is 50 Hz.
n
Image Flip – If mounting the camera upside-down, set Image Flip ON. This orients the video image
n
correctly and sets the tilt motors to respond appropriately to tilt commands from the remote, web
interface, and connected control devices.
UVC Mode – USB stream format. Client Custom enables far-end camera control when used with the
n
Zoom soft client. Use the default UVC Compliant setting with most other conferencing applications.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the light is off.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
28